Manual
Table Of Contents
- ASSEMBLY INSTRUCTIONS
- P3X SERIES PARTS DIAGRAM
- P4X SERIES PARTS DIAGRAM
- GRILL HEAD HARDWARE PACK - B102155
- UNPACK AND REMOVE LID
- INSERT BURNER HOLD-DOWN BOLT
- WIND DEFLECTOR PLACEMENT
- INSERT CONTROL PANEL
- ATTACH IGNITOR WIRE
- INSTALL BURNER ASSEMBLY
- CONNECT IGNITOR LEADS
- KNOB and battery PLACEMENT
- INSTALL LID STOP
- HANDLE INSTALLATION
- REINSTALL LID
- P3XF(N), P4XF(N) FLARE BUSTERS AND RACKS
- P3SX(N) FLARE BUSTERS,SMOKER SHUTTER AND RACKS
- P3X(N) AND P4X(N) BRIQUETS AND RACKS
- INSTALL WARMING RACK
- PROPANE GAS GRILLS
- CONNECTING NATURAL GAS GRILL
- NATURAL GAS GRILLS
- COMPLETED ASSEMBLY
- OWNER’S MANUAL FOR P3X AND P4X GRILLS
- P3X SERIES PARTS DIAGRAM
B102268-1-0615Page 14
Slide the Venturi onto the Valve
Assembly as shown.
Raise end of the Burner Bracket and
slip it over the Phillips Truss Head
Screw. The screw will fit into the hole
on the Burner Bracket.
Insert Cotter Pin.
Note: Ignitor Wires run through center
hole with Venturi.
Insert the Burner Assembly into
the Grill bottom with the Venturi
Tubes facing the front of the Grill.
1
2
3
4
INSTALL BURNER ASSEMBLY
COTTER PIN,
B057805(1)