Spec Sheet

5
www.bromicheating.com
PRODUCT OVERVIEW
1 DESCRIPTION
The Wireless Dimmer is suitable for resistive and infrared heaters. The controller allows the power output of the heater
to be dimmed down for maximum comfort. The control can be used with 110 - 230VAC supply voltages.
1.1 FEATURES
Controls ONE 6500W heater at 230VAC (3400W at 110VAC) or Controls TWO 3200W heaters at 230VAC (1700W at 110VAC).
Wireless control with dimming 0% - 100%.
Wired control capabilities
Configurable soft-start function for increased heater life.
1.2 KIT CONTENTS
Wireless dimmer enclosed in a protective box.
7-channel remote
2. INSTALLATION / SAFETY INFORMATION
Responsibility for determining suitability for use in any application / equipment lies solely on the purchaser. Suitability
for use in your application is determined by applicable standards such as UL, cUL and CE and the completed system
involving this component should be tested to those standards. Please consult with Local authorities and applicable
wiring standards for your application.
WARNING: Operate the Wireless ON/OFF control only when the connected heater is visible to the user.
WARNING: Isolate mains before installing. Use only on with a properly secured heater.
PLUG AND SUPPLY CORD: Use an appropriately rated plug and supply cord - check the power requirements of the
connected loads. Socket outlet used must be near the equipment.
2.1 INSTALLATION
Study the WIRING DIAGRAM at the end of this document before starting installation.
1. Open cover to the box.
2. Setup the DIP switch settings. Use the ‘DIP SWITCH FUNCTION’ section for guideline.
3. Wire in power and heater as per the wiring diagram.
4. Power on the wireless control.
5. Program the wireless control as per ‘OPERATION’ section.
6. Refit cover to the box.
2.2 OPERATION
2.2.1 DIP switch function
WARNING: FIRE HAZARD!! Even quality
electronic components CAN FAIL,
KEEPING FULL POWER ON! Provide a
SEPARATE (redundant) protective device
where advisable and or required by local
codes.
WARNING: HIGH VOLTAGE!! This
controller is used to control HIGH
VOLTAGES and must be installed in a
GROUNDED enclosure by a qualified
electrician in accordance with applicable
local and national codes including NEC
and other applicable codes.
!
!
!
!