Spec Sheet

6
www.bromicheating.com
OPERATION
2.2.2 Programming of 7-channel remote
1. Press P1 once and hold down. A continuous beep will sound.
2. While holding the P1 button (during the continuous beep), press a push button on the 7-channel remote that is
going to be programmed. The programming is confirmed by an intermittent sound. All buttons are automatically
memorised with a preset configuration as in the above drawing.
2.2.3 Programming of 4-channel remote
1. Press P1 twice and hold down. A continuous beep will sound.
2. While holding the P1 button (during the continuous beep), press a push button on the 4-channel remote that is
going to be programmed. The programming is confirmed by an intermittent sound. All buttons are automatically
memorised with a preset configuration as in the above drawing.
2.2.4 Copying a function of remote to a new remote. See remote manual for detail on P3 button.
1. Press the P3 button inside the already programmed remote. The active receiver will sound continuously.
2. Within 5 seconds, press a button of the already programmed remote. The sound will be interrupted, and
continue for another 5 seconds.
3. During the sound, press a button of the new remote that requires to be programmed. The programming is
indicated by an intermittent sound.
Attention: when a 7 channel transmitter is copied, also its levels will be copied into the new one.
2.2.5 Deleting a remote
1. Press the P2 button once and hold it down. There will be a slow and intermittent sound.
2. During the sound, press the button of the remote that will be deleted. The deletion is indicted by a continuous
sound.