Bromic Heating Information Pack SMART-HEATING bromicheating.
Contents Platinum Smart-Heat™ Gas 3 Specifications 4 Dimensions 5 Recommended Installation Clearances 5 Tungsten Smart-Heat™ Gas 7 Specifications 8 Dimensions 9 Recommended Installation Clearances 9 Smart-Heat Gas Wall Bracket Dimensions 11 Smart-Heat Gas Accessories 12 Ceiling Pole 12 Ceiling Pole Paddle Dimensions 12 Smart-Heat Gas Bracket 13 Tungsten Smart-Heat™ Electric 15 Specifications 16 Dimensions 17 Recommended Installation Clearances 17 Pre-Installation Checklist
Top quality performance and the looks to match The brushed stainless steel and ceramic medium makes Platinum Smart-HeatTM Gas suitable for the most exclusive outdoor or home environments. By protecting the tiles behind its translucent ceramic medium, effective heat is guaranteed in winds of up to 11 mph.
Features • • • • • • • • • Full Stainless Steel Construction Higher levels of wind resistance. Platinum units are wind resistant to 11 mph. Electronic ignition. Can be wired into C-Bus and smart system controls Automatic Re-Ignition – In the instance of the unit blowing out, it will attempt to reignite 3 times, if this is unsuccessful the unit will shut down. Use of a ceramic medium creates the most even levels of heat dispersion.
SIDE PROFILE: Slim and streamlined with attractive black wall bracket Dimensions (all measurements are in mm) Recommended Minimum Installation Clearances* OUtdoor Wall mounting** WITHOUT HEAT DEFLECTOR Ceiling pole MOUNTING WITH HEAT DEFLECTOR (heat deflector required for lowclearance installations) CEILING 3’6” WITHOUT HEAT DEFLECTOR (heat deflector required for lowclearance installations) CEILING 3’6” CEILING WITH HEAT DEFLECTOR CEILING 1’2” 1’2” 1’ 1’ 1’ 10’2” 12’6” 1’ 8’ 8’ FLOO
Recommended Mounting Distance* A B B A Model 300 500 A 3’7” 3’7” B 8’2” - 11’5” 8’2” - 11’5” Model 300 500 A 19’8” - 23’ 26’3” - 29’6” Heating Area 5-Series 3-Series 16 ’4 ” ” Heats approx. 200ft2 39,800BTU heating power 8 9’ Heats approx. 120ft2 23,600BTU heating power *Dependent upon ambient conditions and exposure of the area. An installation checklist should always be completed and submitted to Bromic Heating prior to installation.
A designed, costconscious product range that does not sacrifice aesthetics for function The patented direct ignition system, never before seen on an outdoor gas radiant heater, ensures a reliable start and effective operation, even in winds of up to 8 mph. Tungsten Smart-HeatTM Gas 300 Series Propane / Natural Gas Tungsten Smart-HeatTM Gas 500 Series Propane / Natural Gas Stainless steel with high temperature ceramic coating, maximizes long life and durability in tough outdoor environments.
Features • • • • • • • • Full Stainless Steel Construction with special high temperature ceramic coating. Higher levels of wind resistance. Tungsten units are wind resistant to 8 mph. Electronic ignition. Automatic Re-Ignition – In the instance of the unit blowing out. It will attempt to re-ignite, if this is unsuccessful the unit will shut down.
SIDE PROFILE: Stylish curved design with attractive black wall bracket Dimensions (all measurements are in inches) Recommended Minimum Installation Clearances* outdoor Wall mounting** WITHOUT HEAT DEFLECTOR WITH HEAT DEFLECTOR (heat deflector required for lowclearance installations) CEILING 3’6” Ceiling pole MOUNTING WITHOUT HEAT DEFLECTOR 3’6” 1’2” CEILING 1’2” 1’ 1’ 1’ 10’2” 12’6” (heat deflector required for lowclearance installations) CEILING CEILING WITH HEAT DEFLECTOR 1’ 8’ 8’
Recommended Mounting Distance* A B B A Model 300 500 A 3’7” 3’7” B 8’2” - 11’5” 8’2” - 11’5” Model 300 500 A 19’8” - 23’ 26’3” - 29’6” Heating Area 5-Series 3-Series 16 ’6 ” ” Heats approx. 200ft2 43,000BTU heating power 9 0 ’1 Heats approx. 120ft2 26,000BTU heating power *Dependent upon ambient conditions and exposure of the area. An installation checklist should always be completed and submitted to Bromic Heating prior to installation.
Smart-Heat Gas Wall Bracket Dimensions 7.20” 4.61” 8.78” 10.47” 5.91” 5.
Accessories for Smart-Heat Gas Heaters* Ceiling Pole • 90˚ ceiling mounting bracket with 5˚ increments for varied ceiling angles The dual directional ceiling mount pole offers greater positioning versatility. They offer; • Dual or single heater mounting • 6 lengths to suit ceiling heights of 11’, 11’4”, 11’8”, 12’4”, 13’, 13’8” • Adjustable mounting bracket to suit most installations Ceiling Pole Paddles: Ceiling Pole Paddles must be placed with flat fasic facing each other as per diagram.
Accessories for Smart-Heat Gas Heaters* Continued Installation of Ceiling Mount Pole* Our ceiling poles cater for varying ceiling heights and angles. A Position A is the mounting surface of the ceiling mount pole. Please ensure the mounting height (H) has been measured correctly. This diagram illustrates one possible scenario where the mounting surface is angled, and a suspended ceiling is present. (For example, in the case of a suspended ceiling, the ANG mounting surface will be above the ceiling.
Accessories for Smart-Heat Gas Heaters* Continued Dual-layer Heat Deflector • • • • The heat deflector allows for low clearance installations.
An infrared electric heater blending aesthetics and function It’s stylishly designed provides efficient directional heating, compatible with smart control systems to enable precise dimming control with it’s simple one-touch on/off switch. Tungsten Smart-HeatTM Electric 2000W Tungsten Smart-HeatTM Electric 3000W Tungsten Smart-HeatTM Electric 4000W Tungsten Smart-HeatTM Electric 6000W Water / splash resistance, the Tungsten Smart-Heat™ Electric works in almost any weather condition.
Features • • • • • Available in 2000W, 3000W, 4000W and 6000W models Frosted infrared tube heating elements emit warm amber glow – No harsh glare. High temperature corrosion-resistant coating. Tamper-proof electrical wiring enclosure Wall & ceiling mounting options allow for adjustable angle of the heating direction. Specifications Model 2000W 3000W 4000W 6000W Part no. BH0420002 BH0420003 BH0420004 BH0420005 No.
Heating areas (assumed mounting height of 2400mm) Heats up to 65ft2 Heats 2 up to 100ft 13ft 4000W 6000W Heats 2 up to 130ft Heats 2 up to 160ft 15ft 3000W 10ft 10ft 2000W 8.5” 10” Dimensions (all measurements are in mm) 12” 44” 96” (8’) CEILING MOUNTING MINIMUM CLEARANCE TO FLOOR 12” 3.
Pre-Installation Checklist pre-INSTALLATION CHeCKLIST FOr PLATINUM AND TUNGSTeN SMArT-HeAT GAS rADIANT HeATerS PLeASe PHOTOCOPY, COMPLeTe, & SeND THIS CHeCKLIST BY: FAX TO +61 2 9748 4289 or BY MAIL TO Bromic Heating, 1 Suttor Street, Silverwater NSW 2128 Australia or SCAN AND SeND BY eMAIL TO info@bromicheating.
Maintenance and Care: GAS: The heaters are constructed using stainless steel and high temperature coated paint to help ensure maximum life in the outdoor environment. To maximize the life of the heater it is important that frequent cleaning is performed and appropriate care is taken. Bromic recommends the following: Always install with the corresponding Bromic heat shield and clean according to Bromic instructions. Clean the heater weekly during regular use and at least monthly when not in use.
HEAD OFFICE: 1 Suttor Street, Silverwater, Sydney NSW 2128 Australia HEAD OFFICE POSTAL: PO Box 6062, Silverwater, Sydney NSW 1811 Australia T: 1300 276 642 (within Australia) OR +61 2 9748 3900 F: +61 2 9748 4289 E: info@bromicheating.com W: www.bromicheating.com Due to the nature of the printing process, colors shown in illustrations and photographs may vary from the actual product. Bromic Heating Pty Ltd reserves the right to change all drawings, figures and specifications without further notice.