Info Pack

4 5
Features
• Full Stainless Steel Construction
• Higher levels of wind resistance. Platinum
units are wind resistant to 11 mph.
• Electronic ignition. Can be wired into C-Bus
and smart system controls
• Automatic Re-Ignition – In the instance of
the unit blowing out, it will attempt to re-
ignite 3 times, if this is unsuccessful the unit
will shut down.
• Use of a ceramic medium creates the most
even levels of heat dispersion.
• Can be run on LPG or Natural Gas
• Available in two sizes a 300 Series
(23,600BTU) and a 500 Series (39,600BTU)
• Can be wall mounted or ceiling mounted
• Easy Pivot Arm bracket allows for direction
of heat to be adjusted providing greater
versatility and heat coverage
No. of Tiles 300 Series 500 Series
Part no.
LPG
1
BH0110002 BH0110004
Natural Gas
1
BH0110001 BH0110003
Heat Deflector part no.
BH3030001 BH3030002
Ceiling Poles
5 pole lengths to suit ceiling heights of 10.5’, 11.2’, 11.8’, 12.5’ and 13’ (contact Bromic Heating for more
information)
Heat Output (on LPG and NG)
23,600BTU 39,800BTU
Approximate area heated (m
2
)
120ft
2
200ft
2
Gas connection 1/2” NPT Female 1/2” NPT Female
Electrical connection
110 Volt, 3-pin insulated plug 110 Volt, 3-pin insulated plug
Dimension (WxDxHmm)
22.05” x 15.59” x 14.85” 29.76” x 15.59” x 14.85”
Min. distance to combustiable materials
Sides: 3’6’ / 1100mm
(without heat deflector)
Above (to ceiling): 3’6” / 1100mm
(with heat deflector)
Above (to ceiling): 1’2” / 350mm
Mounting height requirement to ground
4
8’ / 2438mm
Weight (kg)
33lb 40lb
1
Must only be installed by a licensed technician. Must complete “Pre-Installation Checklist” before installing
2
The temperature will not exceed 65°C/149°F above the ambient temperature at specified distance. Please consult material
manufacturer for temperature ratings and suitability. Bromic Heating takes no responsibility for material compliance.
3
8’ / 2438mm or maybe lower depending on local regulations
Specifications