Info Pack

8 9
Specifications
Features
• Full Stainless Steel Construction with special
high temperature ceramic coating.
• Higher levels of wind resistance. Tungsten units
are wind resistant to 8 mph.
• Electronic ignition.
• Automatic Re-Ignition – In the instance of the
unit blowing out. It will attempt to re-ignite, if
this is unsuccessful the unit will shut down.
• Can be run on LPG or Natural Gas
• Available in two sizes a 300 Series (26,000BTU)
and a 500 Series (43,000BTU)
• Can be wall mounted or ceiling mounted
• Easy Pivot Arm bracket allows for direction of
heat to be adjusted providing greater versatility
and heat coverage
300 Series 500 Series
Part no.
LPG
1
BH0210002 BH0210004
Natural Gas
1
BH0210001 BH0210003
Heat Deflector part no.
BH3030001 BH3030002
Ceiling Pole
5 pole lengths to suit ceiling heights of 10.5’, 11.2’, 11.8’, 12.5’ and 13’
(contact Bromic Heating for more information)
Heat Output (on LPG and NG) 26,000BTU 43,000BTU
Approximate area heated (m
2
) up to 120ft
2
up to 200ft
2
Gas connection 1/2” NPT Female 1/2” NPT Female
Electrical connection 110 Volt, 3-pin insulated plug
Dimension (WxDxHmm) 19.29” x 14.09” x 14.25” 25.43” x 14.09”x 14.25”
Min. distance to combustiable materials
Side: 3.6’ / 1100mm
(without heat deflector)
2
Above (to ceiling): 3’6’ / 1100mm
(with heat deflector)
Above (to ceiling): 1’2’ / 350mm
Mounting height requirement to ground
3
8’ / 2438mm 8’ / 2438mm
Weight (kg) 33lb 40lb
1
Must only be installed by a licensed technician. Must complete “Pre-Installation Checklist” before installing
2
The temperature will not exceed 65°C/149°F above the ambient temperature at specified distance. Please consult material
manufacturer for temperature ratings and suitability. Bromic Heating takes no responsibility for material compliance.
3
8’ / 2438mm or maybe lower depending on local regulations