Use and Care Manual

1. Place a cup under the water spout.

2. Press the button on top of the unit until a “CLICK” sound is heard. Once clicked, it will provide continuous

water flow.

3. To stop the water flow, press the button again to return it to the initial position

1.Turn the valve on the faucet diverter to the side to route

the flow of water to the filter unit then turn on cold water.

2. Turn the valve up to use faucet as usual.

“CLICK”

For the under-counter T-Valve connection type, water should be diverted permanently to

the unit once you turn the valve to the “on” position.

Tips

HOW TO USE

For Diverter Valve Type

To Drink the Filtered Water

4. After turning on water supply, check all connections for any leaks. Wait 5 minutes and check once more

for any signs of leaking prior to proceeding to next step.

5. Press the button on top of the unit to dispense water (into your sink) and

let it run for 10 minutes to flush the system and activate the filters.

Failure to properly install or check for leaks may cause damage to your

property and Brondell will not be responsible for any damages.

The initial flushed water contains carbon powder and air from the

filter. During flushing of filter, sound will be heard as carbon powder

and air is flushed out. This is not a malfunction, please use the

product as usual after flushing the filter.

Make sure to flush water continuously for at least 10 minutes

before initial use.