INSTALLATION GUIDE Swash IS707 Advanced Bidet Toilet Seats IS707-EW IS707-RW
PRODUCT INSTALLATION INSTALLATION PARTS 1. 2. 3. 4. 5. 1 2 3 4 5 6 2 Mounting Bolt (2) Rubber Cone Washer (2) Flat Washer (2) Nuts (2) Mounting Plate 7 6. Top-Mount Brackets (2) 7. T-Valve Connector with Rubber Washer 8.
BEFORE INSTALLATION DO NOT PLUG THE PRODUCT IN WHILE THE UNIT IS UPSIDE DOWN This may cause damage to the internal components. WATCH OUR INSTALLATION VIDEO Installation for all Swash products can be found online at brondell.com CHECK BOLT SPREAD This bidet can only be installed on toilets with a bolt hole spread of 5.5 inches (see Product Dimensions on Page 7 for more information).
PRODUCT INSTALLATION (cont.) SWASH INSTALLATION (cont.) NOTE: Steps may vary by type of seat and toilet 2. Turn Off Water Supply Valve and Flush Toilet a. Turn water valve off to stop the flow of water. b. Flush toilet and hold down handle to completely empty tank. c. Disconnect water supply hose from toilet tank. Do not disconnect from the water supply valve. NOTES: • You may wish to place a container under the tank to catch any excess water.
SWASH INSTALLATION (cont.) 6. Install Mounting Plate for top-mounted toilet seats (see Page 11, Step 5 for instructions on Standard Installation). This method will use a combination of the included TopMount Brackets and the original toilet seat mounting bolts. a. Place adjustable mounting plate over mounting holes on toilet, rubber side facing down, arrow pointing to the toilet bowl. b. Place the provided Top-Mount Brackets flat side down into the slots of the Mounting Bracket, over the bolt holes. c.
PRODUCT INSTALLATION (cont.) SWASH INSTALLATION (cont.) NOTES: • Make sure to only use a grounded GFCI (ground fault circuit interrupter) electrical outlet. In the case of a short circuit, a grounded GFCI outlet may help prevent electric shock or injury. • If it is necessary to use an extension cord, only use those rated for a minimum of 15 amps with a three-wire extension cord with a three-blade grounding plug. 12. Press the “REAR WASH” button on the control arm to fill the water tank.
WARRANTY Brondell products are backed by some of the most comprehensive warranties in the industry. Brondell warrants that all products (excluding consumable items) shall be free from defects in material and workmanship under normal use and service.
CONTACT: Brondell, Inc. PO Box 470085 San Francisco, CA 94147-0085 Phone: 1-888-542-3355 Email: support@brondell.com Web: www.brondell.com For questions, contact Brondell Customer Service: 1-888-542-3355, Monday – Friday, 9am – 5pm PST MANUFACTURED BY: Brondell, Inc. PO Box 470085 San Francisco, CA 94147-0085 Made in Korea Please retain receipt records for any warranty claims.
