Installation Guide

10
1. Install Bidet Attachment on Toilet
a. Place bidet attachment on the toilet so the
nozzle is as close to the back of the toilet
bowl as it will go. This will vary by toilet.
Step 1a
c. Slide the Pressure Cap down until the cap
meets the Pressure Connector. Screw the
Cap onto the T-Valve until secure and tight.
Caution: Do not over-tighten the Pressure
Cap. You will risk damaging the tubing.
Step 4c
b. Push the Hot Water Flex Tubing over the
Pressure Connector.
Step 4b
CONNECTING THE HOT WATER SUPPLY (cont.)
INSTALLING THE BIDET ATTACHMENT
IMPORTANT: Be sure to slide the Hot Water
Flex Tubing over the Pressure Connector until
the tubing slides past the “lip” of the pressure
connector and it cannot go any further.