Use and Care Guide

STEP 2: T-VALVE INSTALLATION

1. Turn o the cold water supply under the sink at the wall.

Then, turn on the cold water to drain the residual water

from the water lines.

2. Disconnect cold water supply line from the supply valve

under the sink at the wall.

3. Connect the bottom of the 3/8-inch T-valve to the cold water

supply valve at the wall. If the water connection is a 1/2-inch

size, use the provided adapters with rubber washers to

connect the T-valve to the supply line.

4. Re-connect faucet water supply hose to the top of the T-valve

as shown, then insert one end of the orange water supply

tubing into the T-valve 1/4-inch Quick Connector. Be sure to

push rmly into place to secure.

NOTE: See next page for tips on how to use Quick Connectors.

5. Make sure the T-valve is in the closed position (valve arm

should be facing up).

Install the T-valve on the cold water supply only.

Never connect to the hot water supply!

You may wish to place a bucket or container under

the pipes to catch any excess water.

1–2