Use and Care Guide

PRODUCT INSTALLATION (cont.)

3. Align the drain clamp to the hole

a. Take the front half of the drain saddle (with the 1/4-inch

quick connector opening) and unscrew the grey quick

connector from the saddle as shown in diagram 3a.

4. Once the drain clamp is secure and tight on the pipe,

remove the guide and screw the 1/4-inch Quick Connector

back into place.

5. Lastly, insert the white drain tube into the 1/4-inch Quick

Connector on the drain clamp and push rmly into place.

b. Insert a screwdriver, straw, or similar straight thin item into

the front of the rst half of the saddle (to use as a guide) as

shown here in diagram 3b.

c. Insert the end of the guide into the 1/4-inch hole in the

drain pipe and slide the clamp until secure against the

drain pipe. The hole is now properly lined up with the

drain clamp hole. Hold secure by keeping the guide

inserted until the clamp is secured by screwing on the

back side as shown in diagram 3c.

STEP 3: DRAIN CLAMP INSTALLATION (cont.)

4–5