Use and Care Guide

1. Connect the tubes:

a. Connect the open end of the 1/4-inch blue tubing (from

faucet) to the top of the Circle by pushing into the middle

hole labeled “Outlet”.

b. Connect the open end of the white tubing (from the drain

clamp) to the top of the Circle by pushing into the hole

labeled “Drain”.

c. Finally, connect the open end of the orange tubing (from

the water supply T-valve) to the top of the Circle by

pushing into the hole labeled “Inlet”.

d. Be sure to push the ¼” tubing rmly into place to secure.

2. Turn on Water and Check for Leaks

a. Open the T-valve by turning the valve arm 90° and turn

cold water supply back on under the sink at the wall. The cold

water supply will then begin to supply water to the Circle.

b. After turning on the water supply, check all connections for

leaks. Wait 5 minutes and check once more for leaks before

proceeding to the next step.

Failure to properly install this product or to properly

check for leaks may cause damage to the property.

In these instances, Brondell, Inc. will not be held

responsible for any damages.

STEP 4: FINISHING UP

Inlet

Outlet

Drain