Use and Care Guide

10. Replace the battery in the faucet LED indicator to reset the

lter change reminder. The battery type is CR2032 and

Brondell provides one with every set of RF-20 lters.

9. Flush the new lters and the system thoroughly with the

following steps.

a. Turn the provided faucet on all the way for 10 minutes to

purge all the air out of the system.

a. Under the faucet handle, locate the black rubber battery

compartment. Grasp it from the sides and pull down as

shown.

b. After the initial 10 minute purge, turn the provided faucet

o and let the system run for 40 minutes to allow the

water tank to ll.

b. Remove the old battery from the compartment by lifting

the silver metal tab and sliding the battery out of the

rubber casing. Wait 30 seconds for the residual energy to

drain to reset the indicator.

c. Turn the faucet on all the way once more for 10 minutes

(or until the tank empties) to ush the lters and the water

tank.

c. Replace with a new CR2032 battery by sliding the battery

under the silver tab, making sure that the words on the

battery are facing out. A fresh CR2032 battery comes with

every RF-20 Replacement Filter pack.

e. The tank will ll again in approximately 40 minutes, and

then ltered water is ready to drink.

d. Turn the faucet o.

d. Push the black rubber battery compartment back up into

the faucet handle.

10a

10c

10d

FILTER REPLACEMENT (cont.)

HOW TO REPLACE THE FILTERS (cont.)