OWNER’S MANUAL S300-EW S300-RW
This manual contains important safety information. Before operating the unit, please read this manual thoroughly, and retain it for future reference. TABLE OF CONTENTS Section 1 Product Features ......................................................... page 1 Section 2 Safety Precautions ...................................................... page 2-5 Section 3 Parts & C Section 4 Installation ..................................................................... page 8-11 Section 5 Operation .....
PRODUCT FEATURES Ergonomic heated seat with sittable lid – heated seat has four temperature settings (High/Med/Low/O . Posterior and feminine warm water wash – warm water wash with adjustable temperature and pressure settings. Dual anti-bacterial nozzles – separate anti-bacterial nozzles resist soiling and bacterial contamination for enhanced hygiene. T accurate coverage for all types of users.
SAFETY PRECAUTIONS IMPORTANT SAFEGUARDS DANGER: If not observed, serious injury or even death may occur as a result of electrocution. WARNING: READ ALL INSTRUCTIONS BEFORE USING. Save these instructions for future reference.
SAFETY PRECAUTIONS 3
SAFETY PRECAUTIONS WARNING property damage or product damage. used.
SAFETY PRECAUTIONS GROUNDING INSTRUCTIONS • This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape route (wire) for the electric current. This product is equipped with a cord consisting of a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded. The improper use of the grounding plug can result in electric shock.
PARTS & CONFIGURATION The Swash 300 has the following dimensions: The Swash 300: Round Size The Swash 300: Elongated Size Bottom View Distance Between Mounting Holes 70 mm (2.
PARTS & CONFIGURATION Product C ation 1. Lid 7. T-valve connector 2. Warning sticker 8. Power cord 3. IR sensor 9. Drain plug 4. Nozzles 10. 5. Bidet seat 11. Mounting plate 6. Bidet hose 12.
INSTALLATION Installation Parts 1. 2 ea Mounting Bolt 2. 2 ea Rubber Cone Washer 3. 2 ea Flat Washer 4. 2 ea Barrel Nut 5. Mounting Plate 6. 2 ea Adjustable Bracket 7. Rubber T-Valve Washer 8. T-Valve Connector 9. Bidet Hose 10. Remote Control Wall Mount 11. 2 ea Remote Screw 12. 2 ea Remote Anchor 13.
INSTALLATION 9
INSTALLATION 10
INSTALLATION 11
OPERATION Display Controls A A 12
OPERATION Quick Reference Guide: Remote Control Display A B C 13 Controls
OPERATION Quick Reference Guide: Remote Control (continued) 14
OPERATION 15
OPERATION 1. cleansing is operating, the cleansing function will stop.
OPERATION Selecting/Cancelling Eco Mode 1. Press and hold the “Rear cleansing” button on the side of the product and plug the seat back into the electrical outlet. (An alarm will sound and the LED light will turn on.) 2. Press the “F Each time the button is pressed, it alternates between ON and OFF. a. If the bell rings once, Eco Mode is ON. b. If the bell rings twice, Eco Mode is turned OFF. 3. To save the setting, press the Power button on the side of the product.
SPECIFICATIONS 800 W 18
MAINTENANCE 19
MAINTENANCE vertical – 1 TROUBLESHOOTING 20 2
TROUBLESHOOTING Problem The bidet seat is not working Possible Causes Possible Solutions 1. Bidet not plugged in 2. No power to Swash 3. There is power, but nothing happens when trying to use the Swash 4. Not activating body sensor 1. Washing time exceeded the cycle time 2. Power failure 1. Press the wash button during cycle to extend the time (see operation section for more information about wash functions) 2. Check and reset GFI outlet settings 5. Adjust the water pressure settings on the remote.
TROUBLESHOOTING 1b. Residual water may drip into the bowl for several seconds after a wash cycle or self-clean cycle and is not a malfunction.
Brondell Warranty Policy Brondell products are backed by some of the most comprehensive warranties in the industry. Brondell warrants that all products (excluding consumable items) shall be free from defects in material and workmanship under normal use and service. Commercial Warranty: Warranty period 1 year from original purchase date for all Brondell products. Warranties may not apply to products that are used for heavy commercial, hospital, or other high use non-residential applications.
24
For questions, contact Brondell Customer Service: 1-888-542-3355 CONTACT INFORMATION Brondell, Inc. PO Box 470085 San Francisco, CA 94147-0085 Phone: 1-888-542-3355 Email: support@brondell.com Web: www.brondell.com WARRANTY For detailed warranty information and product registration, please go on-line at www.brondell.com Please retain receipt records for any warranty claims.
003 1218189