Operation Manual

ManualsBrandsBrondi ManualsphonesBRAVO CORDLESS 2

6. OPERATIONAL FUNCTION

Introduction

When your cordless is in standby mode, i.e. no calls or operations are being made, the heading

“HS-1” appears on the display (the number identifying the cordless).

6.1 TO ANSWER A CALL

• When you receive a call, both handset and base start ringing, the

symbol appears on the

display, and both the red led on the handset locator button and the big white led on the

phone base start ﬂ ashing.

If your cordless is directly connected to the telephone line (not via PABX) and the Caller

Details Service has been activated by your server, the caller’s telephone number (if available)

appears on the display.

• Press the

button to answer the call, the symbol will come up steadily on the display and

the base red led will ﬂ ash.

• To end a call, press again the

button, or alternatively replace the handset back in the

base. The display symbol and the base red led disappear.

6.2 MAKING CALLS (MANUAL SELECTION)

• Press

button.

• The symbol

appears steadily on the display and the base red led starts ﬂ ashing.

• Check that the dial tone is present then key in the number.

• The dialled number appears on the display.

• To end the call, press again the

button or alternatively replace the handset back in the

base.

6.3 SPEAKERPHONE

To activate the speakerphone, press the

button when the handset is idle or after having

pressed the button.

The speakerphone is active if you can hear the caller voice coming from the speaker and can

see the

and symbols on the display

(hold repeatedely the Volume button to adjust

the speaker volume). To switch back to standard from a spekerphone call, just press brieﬂ y the

button.

6.4 PRE-SELECTION

• When handset is idle key in up to 25 digits.

• You can check the digit on the display before starting your call.

• If you make a mistake, press shortly the DEL button to clear digits one by one from the display;

to clear all digits, press and hold the DEL button.

• When number is checked, press the

button to start the call.

• At this point digits are selected and dialled.

• To end the call, press the

button again, or replace the handset back in the base.

Note: If you have a PABX connection you need to pause for a few seconds between dialing the

system code and the actual phone number.

To pause, press the button and a dash “-” will appear on the display.

BRAVO CORDLESS-2-lingue 6-09-2005, 16:0911