Operation Manual

6.5 LAS NUMBER REDIAL

You can call back the last 3 numbers you have dialled as your cordless stores them in memory.

Last number redial

• Press the phone button

to dial the number.

• Then press the

button to have the number shown on the display.

Note: If you have a PABX connection you need to pause for a few seconds between dialing the

system code and the actual phone number.

To pause, press the

button and a dash “-” will appear on the display.

Redialing any other number than the last one

If necessary, press the Last Number Redial button again until the number

you want is shown

on the display, then press the phone button , to dial the number.

6.6 CALL’S DURATION

When you make or answer a call the display shows the call’s duration in minutes and seconds

both during and a few seconds after the call has ended.

6.7 ADJUSTING THE VOLUME

During a call, to adjust the volume in the hanset’s earpiece or speakerphone press the volume

button repeatedly

The display shows the current volume level: the more “0”, the highest the volume (“0” to

“00000”).

6.8 RINGER VOLUME

• While the handset is idle (not busy on a call) press the volume button.

• Press the or to change the volume.

The display shows the current volume level: the more “0”; the highest the volume (“0” to

“00000”); the symbol shows on the display the ringer is turned off.

• Press the button again to conﬁ rm, otherwise wait a few seconds for the new setting to

be automatically conﬁ rmed and the display to get back to standby mode.

6.9 RINGER MELODY

You have a choice of 9 ringing melodies.

• While the handset is idle (not busy on a call) press the

button and hold it for about 3

seconds, the displlay shows “d

d ” followed by the current ringer melody.

• Press the or button brieﬂ y to hear the different ringing melodies.

• When you reach the melody you prefer press the button again to conﬁ rm, otherwise

wait a few seconds for the new setting to be automatically conﬁ rmed and the display to get

back to standby mode.

6.10 TO MUTE THE MOUTHPIECE

To put the call on hold, so that the person on the other end cannot hear you, press the DEL.

Button brieﬂ y. While the mouthpiece is muted is shown on the display.

To get back the call press the

DEL

button again.

BRAVO CORDLESS-2-lingue 6-09-2005, 16:0212