request of modification.
DECLARATION OF CONFORMITY We, Brondi Telefonia S.p.A., based in ITALY in Via Guido Rossa 16-10024 Moncalieri (TO), hereby declare that the product FX-70 is compliant to the directive 1999/5/CE(R&TTE), and more specifically, is compliant to the following norms: EN300296-2v.1.1.1(2001-03),EN301489-5 v1.3.1(2002-08),EN60065:2002. The conformity is confirmed by the following marking: WARRANTY FOR ITALY The warranty of FX-70 TWIN lasts 12 month.
CATALOGUE 1. Controls and displays .......................................................2 2. Fitting the Batteries .......................................................5 WWW.brondi.it 3. Charging the rechargeable batteries .......................................................6 4. Using the Stopwatch .......................................................8 5. Using the Personal Mobile Radio .......................................................9 6. Cleaning and care .................................
1. Controls and displays WWW.brondi.it TALK button Press and hold while you' re transmitting Up and Down buttons Press to change the speaker Volume.
What' s on the display 1. If the unit is in standby mode Time Stop watch 2. If the unit power ON TX RX Channel number(1to8) SC DCM VOX WWW.brondi.it Sub-channel number(0 to 38) Battery power level. when the bars disapper charge the batteries Shown when you are transmitting the signal Shown when you are receiving the signal Dual watch-shown when you are monitoring two channels at once.
2. Fitting the Batteries Your PMR includes 1.2V AA x 3 rechargeable batteries for each units. Insert your fingernail behind the tab Lift the belt clip off To remove the belt clip It is easier to fit the batteries without the belt clip in place. Pull the tab forward(away from the handset) to release the belt clip. Then lift the belt clip off. WWW.brondi.it To fit the batteries 1.Loosen the screw counter clock wise direction using a coin & open the battery compartment. 2.
3. Charging the rechargeable batteries Lift the charge jack cover located on the side of your unit. Insert the round connector of the 7.5V DC/200mA adaptor into the charge jack. WWW.brondi.it Plug the mains adaptor into a 230V AC ,50Hz main socket with the switch on the socket set to OFF. Then switch ON the main socket. The PMR must be used with mains adaptor, provided with the unit.
Battery Meter The battery meter is located in the lower left side of the LCD panel. These in dicate the amount of power available. As the power is used the bars will disappear. When the battery level reach it minimum level in PMR on mode, unit will emit two beep tones and automatically turn off the power and proceeds to watch mode. WWW.brondi.it Battery Life The PMR has a built in power saver feature to make the batteries last longer.
4. Using the Stopwatch Standby mode(Clock Mode) Installing the battery will automatically turn-on and pr oce eds to Watch mode. To set the Time your Watch has a 24 hour Time clock. In watch mode, press and hold the MENU button for 3 Seconds.The Hour segment in display will flash. WWW.brondi.it Press UP or Down button to increase or decrease the hour number displayed. Press MENU button again to set the minutes. The minutes segment start to flash.
5. Using the Personal Mobile Radio WWW.brondi.it Transmitting range The talk range depends on environmental and terrain. It will be greatest (up to about 3km or 1 3/4 miles) in wide open spaces, without obstructions such as hills or buildings. Don't try to use two PMR handsets which are less than 1.5m (5feet)apart.If you do, you may get interference.
WWW.brondi.it Important safety warning If you are using a head set, to protect your hearing, do not turn the volume to the highest level . To reduce radio frequency exposure when you're using your adventure-100, hold the handset at least 5cm(2inches)from your face. Never use your PMR outdoors in a thunderstorm. Don't use yourPMR in the rain. If your PMR ever get wet, turn it off and remove the battery. Dry the battery compartment and leave the cover off for few hours.
1 Press the MENU button once The current channel number flashes on the display 2 Press UP or Down button to go to the channel you want PTT 3 Press TALK button to confirm. WWW.brondi.it Each channel also has 38 sub-channels(sometime called CTCSS codes) letting you set up group of users within the same channels, for more private communication.If you have a set a sub-channel, you can communicate only with other users tuned to the same channel and sub-channel.
2 Speak clearly into the microphone, in a normal tone - don't shout 3 When you're finished speaking, release the TALK button. To listen to another PMR user Make sure you are not pressing the TALK button Receiving symbol( ) is shown on the display when the other person is speaking. Don't try to transmit until they have finished. WWW.brondi.it Monitoring the current channel Normally Watch PMR will not pick up very weak signals. But you can monitor the current channel for all sounds.
To turn VOX mode ON and OFF: Press MENU button Three times VOX icon display and OF flashes on the LCD panel. 1 Press UP button to set the level of sensitivity. If you press the Down button until OF appear on the display, you can turn off the VOX mode. 2 3 PTT Press TALK button to confirm the setting. As long as the handset in VOX mode, VOX is shown steadily on the display. WWW.brondi.
Setting Call-Ring off If you don't want to hear the call tone, you can set the Call-Ring mode to OFF. In this stage, you can send the call-ring(default callring number 1)to other party but the PMR you held will not sound. 1 Press MENU button for Four times, the unit will enter to Call-Ring setting mode. 2 Press UP or Down button until display OF on t he L CD p anel. WWW.brondi.it 3 CA PTT Press TALK button to confirm your setting.
1 To turn the Key-Tone ON or OFF Press the MENU button Six times. The " On " icon flashes on the display. Press UP or Down button to enable ('On ' will appear on the LCD )or disable (' OF ' Will appear on the LCD) the key tone feature. 2 3 WWW.brondi.it 1 PTT Press TALK button to confirm your setting. Monitoring Two channels at once(Dual Watch) Press MENU button for Seven times. DCM appear on the display while " OF " is flashing. 2 Select the desired channel by pressing UP or Down button.
Scanning Channels When the Scan function is tuned on, the handset will continuously scan the through all eight channels and all 38 sub-channels until it find one on which another user is transmitting. 1 Press MENU and UP button at the same time. SC appears on the display, and channel number change continuously. When a signal is detected, the unit will pause. 2 Press UP button to continue scanning for main channel. 3 Press Down button to scan the Sub-channels. WWW.brondi.
6. Cleaning and care To clean your PMR watch, use a soft cloth dampened with water. Do not use cleaners or solvent, which may cause damage which may not covered by guarantee. 7. Technical specification Operating frequency 446.00625 to 446.09375 MHz(eight channels) Channel spacing 12.5 KHz Output power 0.5 W WWW.brondi.it Channel Channel Frequency(MHz) 1 Frequency(MHz) 446.00625 5 446.05625 2 446.01875 6 446.06875 3 446.03125 7 446.08125 4 446.04375 8 446.
WWW.brondi.it Brondi Telefonia S.P.A info@brondi.
