FX-4 Twin PMR446 Private mobile radio Instruction manual – English
Antenna LCD Screen - Displays the current channel selection and other radio symbols. RECEIVER LED - Lights up when you are receiving signals. PTT (PUSH to TALK) button - Press and hold to transmit. MENU button - Press to change to switch between modes. CALL button - Press to send ringing tone to other PMR units. PWR(POWER) button - Press and hold to turn the unit ON or OFF. UP/DOWN buttons - Press to change channels, volume, and to select settings during programming.
Belt Clip latch 2. Installation 2.1 Removing the Belt Clip a. Pull the Belt Clip latch forward away from the PMR. b. While pulling the Belt Clip latch, push up the Belt Clip as shown in Figure1. 2.2 Installing the Belt Clip a. Slide the Belt Clip into the slot as shown in Figure2. b. A “click” indicates the Belt Clip is locked into position. 2.3 Figure 1 Figure 2 Installing the Batteries a. Open the locking latch and take off the battery compartment cover. b.
3.2 Adjusting the Speaker volume The are 8 volume levels. The current speaker volume level is displayed on the LCD screen. To adjust the speaker volume level, press the ▲(UP) button to increase, or press the ▼(Down) button to decrease. The LCD screen will display the speaker volume icon bars according to the settings. 3.3 Receiving a Call The unit is continuously in Received mode when the unit is turned ON and not transmitting.
3.6.2 Monitor You can use the Monitor feature to check for weak signals on the current channel. a. To activate the Monitor function, press the Menu and the ▲(UP) button at the same time. b. If you hear constant noise and hissing sound press the Menu button once to turn off the monitor function. Note: ● Refer to the “Channel Table” section on this Owner’s Manual for more details. 3.7 Channel Scan Channel scan performs searches for active signals in an endless loop from channel 1 to 8.
4. Auxiliary Features 4.1 Power Saving Your PMR unit has special circuitry designed to extend the life of your battery. When the unit is not used for 4 seconds, it will automatically switch into a low power mode. The Power Saving feature does not affect the PMR’s ability to receive transmission. When a signal is detected, it will automatically return to full power mode. 4.2 Battery Meter Indicator The PMR can detect the battery charge levels.
6. Safety CAUTION Damaged Antenna Do not use any PMR that has a damaged antenna. If a damaged antenna comes in contact with the skin, a minor burn may result. Batteries All batteries can cause property damage and/or bodily injury such as burns if conductive material such as jewelry, keys, or beaded chains touches exposed terminals. The material may complete an electrical circuit (short circuit) and become quite hot.
7. Warranty Like all Brondi products, FX-4 twin has a 24-month warranty. The packing of the FX-4 twin contains a special warranty card which, to be valid, must be: - completely fi lled in; - accompanied by proof of purchase (receipt or invoice, etc.). To correctly fi ll in the warranty card print the name of the product purchased (FX-4 twin) and the serial number (SN) printed under the base (if this is not already printed on the warranty card).
BRONDI S.p.A. www.brondi.it info@brondi.
