Operation Manual

1 Function activated with low sensitivity

2 Function activated with medium sensitivity

3 Function activated with high sensitivity

3. To return to stand-by mode, press and immediately release the

PTT communication button. The parameters set up to now will

be saved. If the VOX function is activated, the word “VOX” will

appear on the display.

6.11 TRANSMISSION OVER TONE (“ROGER BEEP”)

ACTIVATION/DEACTIVATION

The “Roger Beep” is a tone issued by your handset every time you

release the PTT communication button after transmission.

To activate or deactivate this tone, follow the simple programming

procedure described below:

1. Press the MENU button 5 times. The handset will enter the

“Roger Beep” programming procedure and the letters “

ro” will

appear in small print on the display, accompanied by “On” in

big print, ﬂ ashing.

2. Press the + or – buttons to deactivate (“Of” on the display) or

activate (“On” on the display) the tone.

3. To exit this programming procedure, press and immediately

release the PTT communication button; the parameters set up

to now will be saved.

6.12 BUTTON TONES: ACTIVATION/DEACTIVATION

Every time you press a button, your handset issues a tone. You

can activate or deactivate this signal by following the simple

programming procedure described below:

1. Press the MENU button 6 times. The handset will enter the button

tone programming procedure and the letters “

to“ will appear

in small print on the display, accompanied by “On” in big print,

ﬂ ashing.