Owner manual

Brookfield Engineering Laboratories, Inc. Page 15 Manual No. M/98-211-A0701
Figure 9

TORQUE LESS THAN 0%
When Rheometer torque drops below zero (0) percent, the Rheometer will continue to display
torque values preceded by a minus (-) sign. The viscosity and shear stress field will display dashes
(- - - - ) as indicated in the next screen display:
Figure 10
II.3 Spindle Entry
The user can elect to change the spindle selection by pressing the SELECT SPDL key. The DV-III+
control program will use the previously blank line 3 on the default display screen to record the new
spindle input as depicted in Figure 11.
Figure 11
To enter a spindle number, press the numeric keys until the desired spindle number has been entered.
Valid spindle numbers encompass the range from 00 to 99 as listed in Appendix D. Mistakes are
corrected by repeatedly pressing the numeric keys until the proper spindle value has been entered.
At that point, the user presses the SELECT SPDL key again. An invalid spindle entry will result in
a “beep” and the display of the data entry error screen as depicted below.
Figure 12