Owner manual

Brookfield Engineering Laboratories, Inc. Page 32 Manual No. M/98-211-A0701
Figure 43
Pressing the ENTER key would return the user to the default screen, as depicted in its general form
in Figure 42, or to the program start and stop limit selections of Figure 34 if the PROG RUN key
is pressed.
 OPERATION WITH PROGRAMMED SUBSET SPEEDS
Had the user selected a subset of a speed set (Figure 34), say speeds #04 through #08, then the
programmed mode (with a non-zero time interval) would result in the following display:
Figure 44
Here, the user is informed that speed set #2 is being used starting with speed number four and ending
at speed #08 while currently executing speed #04. After the first speed (number #04) is completed,
the display would be updated to show the new speed and the step display would now reflect the
current executing step number as in Figure 45 below.
Figure 45
If the speed set contained no time interval, the selection of a subset of speeds would result in a screen
display as shown in Figure 46.
Figure 46