Owner manual

Brookfield Engineering Laboratories, Inc. Page 49 Manual No. M/98-211-A0701
Click the Delete button to delete the command in the selected row of the program
grid.
Click the Up button to move the command in the selected row of the program grid up
one row.
Click the Down button to move the command in the selected row of the program grid
down one row.
Click the Clear button to clear the grid of all commands. Once cleared, the com-
mands cannot be retrieved.
This list box displayed the commands available for creating
programs. As previously stated, clicking on the Insert
button inserts the highlighted command (WTI in this case)
into the selected line in the program grid. Double-clicking
on a line in this list box also inserts the command into the
grid.
The icons to the left of the command descriptions indicate
the type of command:
A command to wait for a condition.
A command to set a program parameter.
A command to send information to an attached
printer.
Before downloading a program to the Rheometer, ensure the following have been checked:
• The appropriate cable (BEL Part No. DVP-80) is connected between the selected COM port
of the PC and the Rheometer.
• The DV-III+ is at the download screen: OPTIONS/DOWNLOAD A PROGRAM/LOAD TO
SLOT#x where x is slot 1,2,3, or 4.
• With the LOAD TO SLOT #x screen displayed, choose a store slot using the DV-III+ arrow
keys, then press the ENTER/AUTORANGE key on the Rheometer. If after five seconds, the
Rheometer cannot communicate with the RheoLoader program, the B.E.V.I.S. ERROR NO
PC ATTACHED message is displayed. If a connection is established, the Download button
on the PC software becomes enabled, and the DV-III+ screen displays DOWNLOADING