Manual

Brookeld Engineering Labs., Inc. Page 88 Manual No. M13-167-B0614
Step3:
• CompletelyremoveTab1(seeFigureK-3).
• Lightlypressthescreenprotectortothetouchscreen.
• Inspectthealignmentofthescreenprotector.Ifthescreen
protectoristouchingthebezel(frame),themremoveand
reapply.
Step4:
• PeelbackTab2allthewaytoremovethebacking,which
alsoremovesthealignmenttool(seeFigureK-4).Thescreen
protector is now in place.
Step5:
• Usethesoftcardprovidedtopushtrappedairbubblesfrom
thecenterofthescreentotheedge(seeFigureK-5).Small
bubblesshouldgoawaywithin48hours.
• DO NOT use the soft card to push the screen protector
under the bezel (frame).  If the screen protector is not
properlyaligned,removeandreapply.Twoscreenprotectors
are provided in this package in case the rst attempt is
unsuccessful.
• Testtheviscometer(poweron)toensurethatthescreen
protector is properly attached.  The screen protector is
properlyalignediftheDV2TViscometerrespondsnormally
toatouchonthetouchscreen.IftheDV2TViscometeris
unresponsive to touch then remove the screen protector
and reapply.
Removal of the Screen Protector
Thescreenprotectorshouldbereplacedwhenithasbecomedirty.Itcanbeeasily
removedfromtheDV2TViscometerbyhand.Theupperrighthandcornerofthescreen
protectorhasasmallanglecut.Useangernailorbluntobjecttoprythescreenprotector
awayfromthetouchscreenandpeelitofthetouchscreen.
Be careful not to scratch the touch screen when removing the screen
protector.
Figure K-3
Figure K-4
Figure K-5