User's Manual

SERVICE AND ERROR HANDLING 6
27
Transponder Reader – CF-Card, Release 1.1
6 SERVICE AND ERROR HANDLING
6.1 General
 The transponder reader and its components must be serviced by
the manufacturer only.
 If errors occur, follow the instructions in this section. Do not
carry out any error eliminating measures other than the ones
described in this section.
 If you are uncertain about errors and their handling, contact
the manufacturer (see the contact information on page 28 of this
manual). Have the serial number of the transponder reader
ready as shown on the label (see page 14) when contacting the
manufacturer.
6.2 Reader can not be found by the PDA
1 Check the correct position of the card in the CF slot.
2 Remove the card an plug it in again.
3 Check the battery status of the expansion pack.
If these measures do not solve the problem, contact the manufacturer.
6.3 Reader can not be found by the PC/Notebook
1 Check the correct position of the card in the PCMCIA adapter.
2 Check whether the card is installed as COM port in the system
settings of your PC.
3 Install the delivered *.inf file again.
If these measures do not solve the problem, contact the manufacturer.