User's Manual

Product Manual - RFID Reader UF70 Certum 130
Chapter 7
Operation
Parameter 0
(0x00)
Communications port
If the highest value bit 0x80 is set, the device automatically detects the active
communications port. A reset must be completed to change the communications
port. The first message to the reader must then come via the new
communications port.
0x11:
Host  reader: Ethernet
Reader  host: Ethernet
0x13:
Host  reader: Ethernet
Reader  host: Ethernet and RS232
0x22:
Host  reader: RS232
Reader  host: RS232
0x23:
Host  reader: RS232
Reader  host: Ethernet and RS232
Default: (0xA2) automatic detection of the communication port
Parameter 01
(0x01)
Baud rate
Data transmission rate
0x0C: 1,200 Baud
0x18: 2,400 Baud
0x30: 4,800 Baud
0x60: 9,600 Baud
0xC0: 19,200 Baud
0xC8: 38,400 Baud
0xC9: 57,600 Baud
Default: (0xC9) 57,600 Baud (See accompanying letter)
Parameter 03
(0x03)
Parity (read only)
Parameter of the RS232 communication port
Parameter can only be read in the default state!
Values:
0 Even parity
1 Uneven parity
2 No parity
Default: (0x02) No parity