User's Manual

Product Manual - RFID Reader UF70 Certum 43
Chapter 7
Operation
7.2.3 Commands of protocol
Commands
ATTENTION
When using the TCP/IP interface option, the checksum is not used (is not
transmitted).
Command Description
X or URX Read data range of all EPC transponders
URY Read data range of the EPC transponders with special EPC
code
M EPC scanning
URB EPC bulk reading with time specification
W Write EPC of a single transponder
UWW Write data range of all EPC transponders
UWZ Write data range of the EPC transponders with special EPC
code
UMW Write data range masked of all EPC transponders
UMZ Write data range masked of the EPC transponders with special
EPC code
UBW Erase block of all EPC transponders
UBZ Erase block of the EPC transponders with special EPC code
ULW Retrieving all EPC transponders
ULZ Retrieving all EPC transponders with special EPC code
UKW Killing all EPC transponders
UKZ Killing all EPC transponders with special EPC code
T or UAM Activate polling: EPC scanning
UAA Activate polling: Read raw
UAX Activate polling: Read data range
UAW Activate polling: Write data range