User's Manual
Table Of Contents
- Product Manual RFID Reader UF80
- 1 Identification
- 2 Declaration of Conformity
- 3 General Instructions
- 4 Safety Instructions
- 5 Product Specifications
- 6 Installation
- 7 Operation
- 7.1 Operating personnel
- 7.2 Communication protocol ASC-I1
- 7.2.1 Structure of the communication protocol
- 7.2.2 Package contents
- 7.2.3 Commands of protocol
- URY - Read data range (defined EPC code)
- M - Scan EPCs
- W - Write EPC code
- UWZ - Write data range of all EPC transponders (defined EPC code)
- ULZ - Locking all EPC transponders (defined EPC code)
- F - Query parameters
- P - Set parameter
- N - Reset
- O - Set output
- E - Error message
- H - Heartbeat
- V - Query software version
- K - Polling
- UFD - Query DHCP Enabled
- UPD - Set DHCP Enabled
- UFI - Query network settings
- UPI - Set network settings
- UFN - Query host name
- UPN - Set host name
- 7.2.4 Parameter
- Parameter 4 (0x04)
- Parameter 6 (0x06)
- Parameter 11 (0x0B)
- Parameter 12 (0x0C)
- Parameter 16 (0x10)
- Parameter 39 (0x27)
- Parameter 43 (0x2B)
- Parameter 47 (0x2F)
- Parameter 48 (0x30)
- Parameter 50 (0x32)
- Parameter 64 (0x40)
- Parameter 65 (0x41)
- Parameter 66 (0x42)
- Parameter 98 (0x62)
- Parameter 99 (0x63)
- Parameter 118 (0x76)
- Parameter 123 (0x7B)
- Parameter 158 (0x9E)
- Parameter 162 (0x02)
- Parameter 163 (0x00)
- Parameter 176 (0xB0)
- 7.3 Additional information
- 8 Service and Troubleshooting
- 9 Dismantling and Storage
- 10 Transport and Disposal
- 11 Accessories
- Index
Product Manual - RFID Reader UF80 28
Chapter 6
Installation
6.5.1 Positioning the antenna
Reliable reading and writing depends on the distance from and orientation of the
transponder to the antenna.
Depending on the polarization of the antenna and the design of the transponder,
the orientation of the two should be considered when a reliable identification must
be guaranteed.
More information on application-specific antenna structures can be obtained from
our support team.
6.5.2 Available antenna types
Different types of antennas are available on request.
6.6 Power supply
Once the device is connected to the power supply, the power LED lights up.
If the LED does not light up, please refer to the chapter
Error display with
LEDs.
Pin assignment
power supply M12
plug
DANGER
Risk of death from dangerous voltage
Risks exist when supplying the device with incorrect voltage.
Only use cables, plugs and adapters supplied by the manufacturer.
Observe the power ratings of the technical data (
Technical data).
Pin Signal
1 24 V DC+
2 24 V DC-
3 NC
4 NC
5 NC