User's Manual
Table Of Contents
- Product Manual RFID Reader UF80
- 1 Identification
- 2 Declaration of Conformity
- 3 General Instructions
- 4 Safety Instructions
- 5 Product Specifications
- 6 Installation
- 7 Operation
- 7.1 Operating personnel
- 7.2 Communication protocol ASC-I1
- 7.2.1 Structure of the communication protocol
- 7.2.2 Package contents
- 7.2.3 Commands of protocol
- URY - Read data range (defined EPC code)
- M - Scan EPCs
- W - Write EPC code
- UWZ - Write data range of all EPC transponders (defined EPC code)
- ULZ - Locking all EPC transponders (defined EPC code)
- F - Query parameters
- P - Set parameter
- N - Reset
- O - Set output
- E - Error message
- H - Heartbeat
- V - Query software version
- K - Polling
- UFD - Query DHCP Enabled
- UPD - Set DHCP Enabled
- UFI - Query network settings
- UPI - Set network settings
- UFN - Query host name
- UPN - Set host name
- 7.2.4 Parameter
- Parameter 4 (0x04)
- Parameter 6 (0x06)
- Parameter 11 (0x0B)
- Parameter 12 (0x0C)
- Parameter 16 (0x10)
- Parameter 39 (0x27)
- Parameter 43 (0x2B)
- Parameter 47 (0x2F)
- Parameter 48 (0x30)
- Parameter 50 (0x32)
- Parameter 64 (0x40)
- Parameter 65 (0x41)
- Parameter 66 (0x42)
- Parameter 98 (0x62)
- Parameter 99 (0x63)
- Parameter 118 (0x76)
- Parameter 123 (0x7B)
- Parameter 158 (0x9E)
- Parameter 162 (0x02)
- Parameter 163 (0x00)
- Parameter 176 (0xB0)
- 7.3 Additional information
- 8 Service and Troubleshooting
- 9 Dismantling and Storage
- 10 Transport and Disposal
- 11 Accessories
- Index
Product Manual - RFID Reader UF80 40
Chapter 7
Operation
Address of the device ("0" .. "E").
The default address of the card is 0 on delivery.
Brooks recommends leaving the reader ID at "0", since the device can be clearly
identified via its IP connection.
This feature is not used for the individual reader. This code is always "0000".
The result flag delivers information on whether an action was completed
successfully. The data are interpreted in HEX format. This means that two ASCII
characters in the message equal one byte of data in HEX format.
Values:
0x00 no errors occurred
0x0A no transponder was found
0x0B several transponder were found
0x70 transponder could not be selected during the transponder
operation
0x71 structure of W command not in line with specifications
Contains the 4-byte serial number of the device.
The serial number is also shown on the label of the reader.
Reader ID 1 byte
Response code 4 bytes
Result 2 bytes
IMPORTANT
For writing operations to the transponder, the transponder error code must also
be analyzed to be able to make an assessment as to whether the action was
competed successfully.
Serial number 4 bytes