User Guide

PRINT CLAMPS

Print Clamp Instructions

PC618

PC624

PC630

PC636

PC642

A B

1) Loosen wing knobs on top of clamp turning counter clockwise. Pull jaws out from “U” channel and the clamp

will open.

2) Insert files into clamp jaw and hand tighten wing knobs until the files are secure. Print clamp shown

is a cut-away diagram to show the internal mechanism.

Page: 1 / 2

PAGE 1
PRINT CLAMPS Print Clamp Instructions PC618 PC624 PC630 PC636 PC642 A B 1) Loosen wing knobs on top of clamp turning counter clockwise. Pull jaws out from “U” channel and the clamp will open. 2) Insert files into clamp jaw and hand tighten wing knobs until the files are secure. Print clamp shown is a cut-away diagram to show the internal mechanism.
PAGE 2
PRINT CLAMPS Installation Instructions C How to attach a clamp to a pivot bracket? 1) Make certain that the pivot bracket is installed properly on the rack with the spring on top. 2) Insert clamp clip (on top of clamp) as shown at an angle and push forward and then down to horizontal 3) Once completely inserted on the hanger, gently pull the hanger away from the rack until the rear knob on the clamp pulls over the mounting plate.