Operating instructions

Assembly
The images below detail the sequence for installing the internal firebricks in the eVolution 4
1. Ensure there is no ash are debris to prevent the
firebricks installation.
2. Start by installing the left side firebrick as shown.
3. Insert the right side firebrick but this time lean it towards
the left brick as shown.
4. Insert the baffle, lift the baffle upwards towards the roof
with one hand and with your other hand stand the right
firebrick upright as shown. You can now lower the baffle
so that it rests on each of the side firebricks as shown.
5. Insert the rear firebrick, use one hand to lift the baffle up
slightly then position the rear firebrick and lower the
baffle onto it as shown.
6. Finally install the log retainer one side at a time.
To remove the firebricks simply reverse this sequence.
MS11-11 Issue 3 13