User's Manual

Chapter 4
21
Routine maintenance 4
Charging the battery 4
If your battery is getting low, you should
charge the battery. You can see the battery
strength at the bottom right of the LCD.
a Plug the cradle into the AC power outlet.
b Place the cordless handset in the cradle
with the dial pad facing forward.
Cleaning 4
Clean the outside of the cordless handset.
You should also clean the charger charge
contacts. If the charger contacts are not
clean, the battery may not be charged.
CAUTION
Use neutral detergents. Cleaning with
volatile liquids such as thinner or benzine
will damage the outside surface of the
cordless handset.
DO NOT use cleaning materials that
contain ammonia.
DO NOT use isopropyl alcohol to remove
dirt from the control panel. It may crack the
panel.
Clean the charger contacts as follows: 4
a Unplug the cradle from the AC power
outlet.
b Clean the charger contacts (1) for both
the cordless handset and the cradle with
a cotton swab.
Not
Registered
You tried to access a Tel-Index
number that is not programmed.
Set up the Tel-Index number. (See Storing
numbers for easy dialing on page 9.)
Searching for
Base Unit
(Base Unit not
detected)
The cordless handset is too far from
the machine (base unit).
Bring the cordless handset closer to the machine
(base unit).
The machine (base unit) is turned
off.
Make sure the machine (base unit) is turned on.
(Optional cordless handset only)
You have not registered the
cordless handset.
Register the cordless handset. (See Registering
additional cordless handsets on page 3.)
Error Message Cause Action
(MFC-845CW)
1