Service manual

- IV-6 -
1.3 Replacing the Roll ASSY
1) Release the cover feed secured to the paper tray at one point and open the cover
feed.
2) Release the hook securing the roll ASSY to the shaft retard from the paper tray.
3) Pull out the roll ASSY from the shaft retard.
Fig.4-16
4) Push the new roll ASSY into the shaft on the paper tray.
1.4 Description of Procedures
Note:
In the procedures, directions are represented as follows.
Front: Front when you are facing the front of this laser printer.
Rear: Inner direction when you are facing the front of this laser printer.
Left: Left hand when you are facing the front of this laser printer.
Right: Right hand when you are facing the front of this laser printer.
Fig.4-17
Note:
The screws in the illustrations should be removed using a cross head screwdriver unless
otherwise specified.
Note:
A black arrow in the illustrations indicate movement in the direction of the arrow.
Numbered black arrows indicate the order of the movement.
Note:
For the positions of the connectors (P/J), refer to Chapter 7, Plug/Jack(P/J) Connector
Locations.
Note:
Assembly is the harness of disassembly unless otherwise stated.
Rear
Left
Ri
g
ht
Front
Cover feed
Roll ASSY