Service manual

- IV-20 -

8) Remove the ring E on the right and left shaft pivot securing the bottom portion of the

chute ASSY out and chute ASSY IN.

CAUTION

In the following steps, take care not to hurt your hand with burrs of the plate ASSY

bottom MSI.

9) Pull out the left shaft pivot from the chute ASSY out inward with radio pliers.

10) Pull out the right shaft pivot from the chute ASSY out inward with radio pliers.

11) Release latch A and pull the chute ASSY out complete with chute ASSY IN forwards

to remove them from the printer.

12) Remove the strap connecting chute ASSY out to chute ASSY IN.

Fig.4-37

13) Release latch B to separate the chute ASSY IN from the chute ASSY out.

Fig.4-38

Ring E

Shaft pivot

Chute ASSY out

Front ASSY in