Service manual

I-12
8.12 Continuous Printing Speed
Assuming the time until the trailing end of the 11th sheet is discharged after the trail end
of the 1st sheet is discharged as t seconds, number of printed sheets for a minute given
by the equation [60/t ×10] is shown in the table below, excluding, however, the time for
which the process control is working and during the Fuse Cool Down are not contained.
Note:
This function specifies the IOT performance when the controller did not have the ×2
feeders satisfy the following performance.
Refer to Chart 6 Principles Of Operation, for details of Process control.
Reference:
Unit "PPM" stands for "prints per minute" indicating number of prints per minute.
"ipm" is abbreviation of "Impression Per Min", and indicates "number of printed sides per
minute" for Duplex.
Continuous printing speed
Full speed (600dpi) Half speed
(600/1200dpi)
Paper mode
Simplex
(ppm)
Duplex
(ipm)
Simplex
(ppm)
Duplex
(ipm)
Plain paper
(A4/LET SEF)
24/26 15.1/15.4 12/13 7.7/7.9
Thick paper
(-162gsm)*1
(A4/LET SEF)
-- -- 12/13 7.7/7.9
Thick paper
(163-216gsm)
/Label/OHP *1
(A4/LET SEF)
-- -- 12/13 --
Envelop/Postcard -- -- 13 --
*1:In case of small size paper, printing speed is sometimes slowed down.
8.13 Printing Area
8.13.1 Usable paper size
Minimum and maximum paper size usable for this printer are as follows:
Minimum usable paper size:Width 88.9mm (3.5inch) × length 139.7mm (5.5 inch)
(when using MSI).
Maximum usable paper size:Width 215.9mm (8.5 inch) × length 355.6mm (14 inch)
(when using MSI).
8.13.2 Maximum printable area
For each printable size of paper, this printer masks 2.5mm within the left edge and right
edge, 2.0mm from within edge and back edge as unprintable area, in order to prevent
from that images exceed the size of printable area.
Maximum area where image can be printed is as follows:
Width: 210.9mm (8.3 inch) × length: 351.6mm (13.8 inch)