User`s guide
Table Of Contents
- Definitions of warnings, cautions, and notes
- To use the printer safely
- Brother Numbers (USA and Canada)
- Frequently asked questions (FAQs)
- Important information: Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (For USA)
- Industry Canada Compliance Statement (For Canada)
- Radio interference (220 to 240 volt model only)
- International ENERGY STAR® Compliance Statement
- Laser Safety (100 to 120 volt model only)
- FDA Regulations (100 to 120 volt model only)
- IEC 60825 specification (220 to 240 volt model only)
- IMPORTANT - For Your Safety
- Trademarks
- Table of Contents
- About this printer
- Driver and software
- Control panel
- Options
- Routine maintenance
- Troubleshooting
- Appendix
- INDEX
CONTROL PANEL 3 - 7
Control panel buttons
The control panel buttons have the following functions:
Cancel printing
If you press the Job Cancel button while printing, the printer will immediately stop printing and will then
eject the paper.
Wake-up
If the printer is in Sleep mode, press the Go or Job Cancel button to wake the printer up and go to the
Ready state.
Form feed
If the yellow Status LED is on, press the Go button. The printer will print any data that is left in the printer
memory.
Error recovery
If there is an error, the printer will recover automatically from some errors. If an error is not automatically
cleared, press the Go button to clear the error, and then continue to use the printer.
Reprint
If you want to reprint a document that has just been printed, you can do this by pressing and holding
down the Go button until all four LEDs are lit and then release the Go button.