Barcode Utility User's Guide
Table Of Contents
- Barcode Utility User’s Guide
- Definitions of Notes
- Copyright
- Trademarks
- Table of Contents
- 1. Introduction
- 2. Monitor Folders and Process Files
- 2.1 Requirements
- 2.2 Add a Folder to Be Monitored (Hot Folder)
- 2.3 Create a File Processing Rule
- 2.4 Assign Barcodes to File Processing Rules
- 2.5 Configure File Split Settings
- 2.6 Configure File Rename Settings
- 2.7 Configure File Save Settings
- 2.8 Configure Common Settings
- 2.9 Start Folder Monitoring and File Processing
- 3. Additional Features
- 4. Check the Application Log
- 5. Troubleshooting
- Appendix A: Barcode Recognition Requirements
- Appendix B: Custom Naming Rules
- Appendix C: Supported Barcode Types and Options
- Appendix D: XML Specification for Barcodes
31
Error Solution
This file splitting
rule is not
registered.
Register a new file splitting rule. For more information, see section 2.5 Configure File
Split Settings.
Unregistered file
renaming rule.
Register a new file renaming rule. For more information, see section 2.6 Configure File
Rename Settings.
Unregistered file
save rule.
Register a new file save rule. For more information, see section 2.7 Configure File
Save Settings.
Non-supported PDF
type detected.
・ Make sure the Barcode Utility is activated on your Brother machine.
・ Check the scan settings of the machine used to scan into the hot folder.
・ Make sure the PDF type is normal PDF (The Searchable PDF, Secure PDF, and
High compression PDF types are not supported). For more information, see
section 1.3 Supported Input/Output File Formats.
・ If the issue is not resolved, contact your local Brother office.