Network User's Guide
Table Of Contents
- Network User’s Guide
- Table of Contents
- 1 Introduction
- 2 Changing Your Network Settings
- 3 Configuring Your Machine for a Wireless Network (ADS-2800W / ADS-3600W)
- Overview
- Confirm Your Network Environment
- Configuration
- Configuration in Ad-hoc Mode
- Configure Your Machine for a Wireless Network Using the Machine’s Control Panel Setup Wizard
- Use Wi-Fi Direct®
- Scan from Your Mobile Device Using Wi-Fi Direct®
- Configure Your Wi-Fi Direct® Network
- Wi-Fi Direct® Network Configuration Overview
- Configure Your Wi-Fi Direct® Network Using the One-Push Method
- Configure Your Wi-Fi Direct® Network Using the One-Push Method of Wi-Fi Protected Setup™ (WPS)
- Configure Your Wi-Fi Direct® Network Using the PIN Method
- Configure Your Wi-Fi Direct® Network Using the PIN Method of Wi-Fi Protected Setup™ (WPS)
- Configure Your Wi-Fi Direct® Network Manually
- 4 Web Based Management
- Overview
- Configure Your Machine Settings
- Set a Login Password
- Use LDAP Authentication
- Restrict Users
- Synchronize with the SNTP Server
- Change the Scan to FTP Configuration
- Change the Scan to SFTP Configuration
- Change the Scan to Network Configuration (Windows®)
- Change the Scan to SharePoint Configuration (Windows®)
- Configure TCP/IP Advanced Settings
- Address Book Import/Export (ADS-2800W / ADS-3600W)
- 5 Scan to E-mail Server (ADS-2800W / ADS-3600W)
- 6 Security Features
- 7 Troubleshooting
- 8 Additional Network Settings (Windows®)
- A Appendix
- B Index
Configuring Your Machine for a Wireless Network (ADS-2800W / ADS-3600W)
30
3
5 Do one of the following:
• If you are using an authentication and encryption method that requires a Network Key, enter the
Network Key you wrote down in the first step.
When you have entered all the characters, press OK, and then press Yes to apply your settings.
• If your authentication method is Open System and your encryption mode is None, go to the next step.
• If your WLAN access point/router supports WPS, The selected access point/router
supports WPS. Use WPS? appears. To connect your machine using the automatic wireless mode,
press Yes. (If you selected No (Manual), enter the Network Key you wrote down in the first step.)
When Start WPS on your wireless access point/router, then press [Next].
appears, press the WPS button on your WLAN access point/router, and then press Next.
6 The machine attempts to connect to the wireless device you selected.
If your wireless device is connected successfully, the machine’s LCD displays Connected.
You have completed the wireless network setup. To install the drivers and software necessary for operating
your machine, insert the installation DVD-ROM into your computer’s drive or go to your model’s Downloads
page on the Brother Solutions Center at support.brother.com