Network User's Guide
Table Of Contents
- Network User’s Guide
- Table of Contents
- 1 Introduction
- 2 Changing Your Network Settings
- 3 Configuring Your Machine for a Wireless Network (ADS-2800W / ADS-3600W)
- Overview
- Confirm Your Network Environment
- Configuration
- Configuration in Ad-hoc Mode
- Configure Your Machine for a Wireless Network Using the Machine’s Control Panel Setup Wizard
- Use Wi-Fi Direct®
- Scan from Your Mobile Device Using Wi-Fi Direct®
- Configure Your Wi-Fi Direct® Network
- Wi-Fi Direct® Network Configuration Overview
- Configure Your Wi-Fi Direct® Network Using the One-Push Method
- Configure Your Wi-Fi Direct® Network Using the One-Push Method of Wi-Fi Protected Setup™ (WPS)
- Configure Your Wi-Fi Direct® Network Using the PIN Method
- Configure Your Wi-Fi Direct® Network Using the PIN Method of Wi-Fi Protected Setup™ (WPS)
- Configure Your Wi-Fi Direct® Network Manually
- 4 Web Based Management
- Overview
- Configure Your Machine Settings
- Set a Login Password
- Use LDAP Authentication
- Restrict Users
- Synchronize with the SNTP Server
- Change the Scan to FTP Configuration
- Change the Scan to SFTP Configuration
- Change the Scan to Network Configuration (Windows®)
- Change the Scan to SharePoint Configuration (Windows®)
- Configure TCP/IP Advanced Settings
- Address Book Import/Export (ADS-2800W / ADS-3600W)
- 5 Scan to E-mail Server (ADS-2800W / ADS-3600W)
- 6 Security Features
- 7 Troubleshooting
- 8 Additional Network Settings (Windows®)
- A Appendix
- B Index
Troubleshooting
94
7
I am using security software. 7
Question Interface Solution
Did you select Accept in the
security alert dialog box
during the Brother Device
installation, applications’
start-up process, or when
using the scanning
features?
wired/
wireless
If you did not select Accept in the security alert dialog box, the firewall
function of your security software may be denying access. Some security
software might block access without showing a security alert dialog box.
To allow access, see your security software instructions or ask the
manufacturer.
I want to know the
necessary port number for
the security software
settings.
wired/
wireless
The following port numbers are used for Brother network features:
Network scanning i Port number 54925/Protocol UDP
Network scanning, Remote Setup
1
i Port number 161 and
137/Protocol UDP
BRAdmin Light
1
i Port number 161/Protocol UDP
1
Windows
®
only.
For information about how to open the port, see the security software
instructions or ask the manufacturer.