Electronic Typewriter User's Guide

Replacing the cassette ribbon

Two types of ribbons are available:

Ribbon Types Brother Model

Correctable film ribbon t 030 / 1230

Nylon ribbon i 1032

To replace the cassette ribbon:

1) Use [SPACE BAR] or Hto move the carrier to the

centre of the platen,

2) Open the top cover.

3) Holding the cassette with both hands, lift the front of

the cassette up and out.

4) Move the cassette towards the platen to remove it.

5) Turn the feed knob (on the left side of the cassette)

counter-clockwise to tighten the ribbon in the new

cassette.

6) Align the arrow on the cassette with the arrow on the

cassette holder. Use both hands to ease the cassette

into the holder, back first.

7) Gently press down on the front of the cassette until it

clicks into place.

8) Again turn the feed knob counter*clockwise to take up

any slack.

9) Close the top cover.

10) Press _ +//to move the carrier to the previous

position.

The amount of tape remaining can be checked

,through the viewing hole on the right side of the

cassette.

Make sure to use only Brother-authorized cas-

sette ribbons, correction tapes and cassette daisy

wheels. Brother cannot be held responsible for

difficulties caused by the use of unauthorized

supplies.

Note; Please do not touch the keyboard during replacing the daisy wheel, cassette J

ribbon or correction tape in order to avoid carrier movement.

-Page i0-