Instruction manual

7. SEWING
35
KE-436C
5. Step on the work clamp switch (6) to raise the work
clamp.
6. Insert the work piece under the work clamp, and press
the work clamp switch (6) to lower the clamp.
7. Press the start switch (7).
Note:
The work clamp will return to the origin, and will then
advance to the sewing start position and blinking will
stop. This is only required the first time a program is
sewing.
8. Press the start switch (7) again to start sewing.
9. After sewing is completed, the thread cutter will
automatically operate, then the work clamp will rise.
Note:
When the power is turned on after once being turned off, the same pattern of sewing can be continued since the machine
will stores the sewing data from the last time.
2720Q