Instruction manual

11. CHANGING SPECIAL FUNCTIONS USING THE MEMORY SWITCHES
54
KE-436C
Memory switches (20 - 2F)
Switch No. Motion when set to ON Initial value
memo-20
During feed test operation, jump feeding 100 stitches at a time is possible using the STEP
BACK switch.
−
memo-21
After the home position is detected and the machine moves to the sewing start position, the
work clamp rises automatically.
−
memo-22 − −
memo-23 − −
memo-24 − −
memo-25
The enlargement and reduction ratio settings at the operation panel are fixed at the values
when memo-25 was set to ON.
−
memo-26 Thread trimming is not carried out. −
memo-27
The sewing speed setting at the opration panel is fixed at the value when memo-27 was set
to ON.
−
memo-28 Set to ON when using the thread take-up device. ON
memo-29 Work clamp lifting and lower thread winding before home position detection are disabled. −
memo-2A − −
memo-2b − −
memo-2c − −
memo-2d − −
memo-2E − −
memo-2F
When the input voltage is being checked, the display shows the temperature of the heat sink
on the main circuit board instead of the voltage.
−
− : OFF