Instruction manual

7. Sewing

BAS-343E

5. Depress the work clamp lift pedal y to raise the cas-

sette holding pin.

6. When the cassette is inserted into the mounting sup-

port, the sensor will detect it automatically and the

cassette will be clamped in place. At this time, the aux-

iliary work clamp will be lowered.

7. Press the starting pedal u.

NOTE

The work clamp will return to the origin, and will

then advance to the sewing start position and

blinking will stop. This is only required the first

time a program is sewing.

8. Press the starting pedal u again to start sewing.

9. When sewing is finished, the thread will be trimmed

automatically, and then the auxiliary work clamp will

be raised and the cassette will come away from the

pin.

NOTE

When the power is turned on after once being turned off, the same pattern of sewing can be continued

since the machine will stores the sewing data from the last time.

During automatic sewing (after the cassette is clamped)

Set DIP switch A-7 to ON.

1. Depress the work clamp lift pedal ys to raise the cassette holding pin.

2. When the cassette is inserted into the mounting support, the sensor will detect the cassette automatically and it will

be clamped in place. After the feed mechanism has returned to the home position, it will move to the sewing start

position and the program cover will stop flashing. This happens only for the first sewing operation after a program

has been selected.

3. When the start pedal y is depressed, sewing will start.

4. Same as step 9. above.

5. At the second sewing operation, or if the cassette is removed and re-inserted, the sensor will detect the cassette

automatically and sewing will start immediately.

* The delay time from the point when the sensor detects the cassette to the start of sewing can be set using memory

switch 38 to between 0.1 and 2 seconds in steps of 0.1 of a second.

Auxiliary

work clamp

Cassette