Owner's Manual

9
LK3-B430E-, B431E-, B432E-, B433E- Mark II
q
w
e
r
y
u
q
e
Table
1mm
t
q
w
e
3-2 . Installing the motor
Install the motor u to the work table with the four ac-
cessory bolts q, cushions w, cushion collars e, flat
washers r, spring washers t and nuts y.
At that time, fix by setting bolts q a little to the right
of oval hole on motor.
NOTE:
Tighten the nuts y so that the clearance between the table
and the cushion collars e is approximately 1 mm.
3-3 . Installing the motor pulley
Place the motor pulley q onto the shaft of the motor
w so that the key groove is aligned, and then tighten
the set screw e so that the center of the V groove in
the motor pulley q is aligned as closely as possible
with the center of the belt hole in the power table.
3. INSTALLATION