Setup guide

Gently push the ink cartridge until it clicks. After

all the ink cartridges are installed close the ink

cartridge cover.

Check the print quality

a When the preparation process has finished, the

LCD shows this message

Set Paper and

Press Start

Press Colour Start.

b Check the quality of the four colour blocks a

on the sheet. (black/yellow/cyan/magenta)

c If all lines are clear and visible, press a (Yes) to

finish the quality check and go to step 7.

If you can see missing short lines, press b (No)

and go to d.

d The LCD asks you if the print quality is OK for

black and colour. Press a (Yes) or b (No).

Black OK?

a Yes b No

Color OK?

a Yes b No

After pressing a (Yes) or b (No) for both black

and colour, the LCD shows:

Start Cleaning?

a Yes b No

e Press a (Yes), the machine will then start

cleaning the colours.

f After cleaning is finished, press Colour Start.

The machine starts printing the Print Quality

Check Sheet again. Go back to b.

Note

The machine will prepare the ink tube system for

printing. This process will take approximately four

minutes. Do not turn off the machine.

Poor