User Manual
Table Of Contents
- SOFTWARE USER’S GUIDE
- Table of Contents
- Windows®
- Printing
- Scanning
- ControlCenter3
- Remote Setup (Not available for DCP models, MFC-253CW, MFC-255CW, MFC-257CW and MFC-295CN)
- Brother PC-FAX Software (MFC models only)
- PhotoCapture Center™
- Firewall settings (For Network users)
- Apple Macintosh
- Printing and Faxing
- Scanning
- ControlCenter2
- Remote Setup & PhotoCapture Center™
- Using the Scan key
- Index
- brother CHN-ENG
USB cable scanning
169
12
k If you do not want to change additional settings, press Mono Start or Colour Start to start scanning.
l The number of the scanned documents appear on the LCD.
Press OK.
m Press d or c to preview each document data.
n Press OK to save the data.
Press Stop/Exit.
Note
Scan type depends on the settings you choose in step e to f, Mono Start or Colour Start do not change
the setting.
For Touchscreen models 12
a Put a memory card or USB Flash memory drive into your machine.
CAUTION
DO NOT take out the memory card or USB Flash memory drive while Photo Capture is blinking to avoid
damaging the card, USB Flash memory drive or data stored on the card.
If you take out the memory card or USB Flash memory drive while the Photo Capture key is flashing, you
must restart your computer at once before putting the same memory card or USB Flash memory drive into
the machine. If you do not restart your computer, the data on your media may be destroyed.
b Load your document.
c Press (Scan).
d Press Scan to Media.
Do one of the following:
If you want to change the quality, go to step e.
Press Mono Start or Colour Start to start scanning without changing additional settings. Go to
step h.
e Press Quality and then press the quality you want.
Do one of the following:
If you want to change the file type, go to step f.
Press Mono Start or Colour Start to start scanning without changing additional settings. Go to
step h.