User Manual
Table Of Contents
- Product Safety Guide
- Symbols and conventions used in the documentation
- Compilation and Publication Notice
- Choose a safe location for your product
- General precautions
- Connecting the product safely
- Servicing the product
- Product Warranty & Liability
- Approval Information (MFC only)
- Declaration of Conformity (Europe only) (HL-5470DW / HL-6180DW(T) / MFC-8510DN / MFC-8520DN / MFC-8950DW(T) only)
- Declaration of Conformity (Europe only) (HL-5440D / HL-5450DN(T) / DCP-8110DN / DCP-8250DN only)
- IEC60825-1:2007 Specification (For 220-240V Models Only)
- Disconnect device
- LAN connection (Network models only)
- Radio interference
- Recycling information in accordance with the WEEE (2002/96/EC) and Battery (2006/66/EC) Directives
- International ENERGY STAR® Qualification Statement
- Trademarks
- Open Source Licensing Remarks
- Copyright and License
- Other Information
- Unlawful use of copying equipment (MFC and DCP only)
6
Avoid using this product during an electrical storm. There may be a remote risk of electric shock
from lightning.
Be careful not to inhale the toner powder. In the unlikely event that toner is inhaled, please follow
these steps immediately:
• Move to an area with plenty of fresh air.
• Gargle and rinse your mouth out with plenty of water.
• If you develop a cough or any other symptoms brought on by the inhalation of the toner,
please consult your doctor immediately.
If you happen to swallow some toner powder, rinse your mouth and drink plenty of fresh water
to dilute the toner. Then, please consult your doctor immediately. For more safety information
regarding the toners used in your product, please visit the following web address to read the
Safety Data Sheets http://sds.brother.co.jp/sdsapp/index.html
. These will include important
information about the chemical composition of the toners and also the precautions to take if you
happen to become overexposed to toner.
HOT SURFACE
After you have just used the product, some internal parts of the product will be extremely hot.
Wait at least 10 minutes for the product to cool down before you touch the internal parts of the
product.
(MFC and DCP only)
When moving the product, grasp the side handholds firmly from the front of the product. The
side handholds are located under the scanner. DO NOT carry the product by holding it at the
bottom.