User Manual
Table Of Contents
- Product Safety Guide
- Symbols and conventions used in the documentation
- Compilation and Publication Notice
- Choose a safe location for your product
- General precautions
- Connecting the product safely
- Servicing the product
- Product Warranty & Liability
- Approval Information (MFC only)
- Declaration of Conformity (Europe only) (HL-5470DW / HL-6180DW(T) / MFC-8510DN / MFC-8520DN / MFC-8950DW(T) only)
- Declaration of Conformity (Europe only) (HL-5440D / HL-5450DN(T) / DCP-8110DN / DCP-8250DN only)
- IEC60825-1:2007 Specification (For 220-240V Models Only)
- Disconnect device
- LAN connection (Network models only)
- Radio interference
- Recycling information in accordance with the WEEE (2002/96/EC) and Battery (2006/66/EC) Directives
- International ENERGY STARĀ® Qualification Statement
- Trademarks
- Open Source Licensing Remarks
- Copyright and License
- Other Information
- Unlawful use of copying equipment (MFC and DCP only)
9
Connecting the product safely A
WARNING
There are high voltage electrodes inside the product. Before you clean the inside of the product,
make sure you have unplugged the telephone line cord first (MFC only) and then the power cord
from the electrical socket. Doing this will prevent an electrical shock.
DO NOT handle the plug with wet hands. Doing this might cause an electrical shock.
Always make sure the plug is fully inserted.
This product should be connected to an AC power source within the range indicated on the
rating label. DO NOT connect it to a DC power source or inverter. If you are not sure, contact a
qualified electrician.
DO NOT allow anything to rest on the power cord. DO NOT place this product where people can
walk on the cord.
To ensure safe operation, the supplied three-pin plug must be inserted only into a standard
three-pin electrical socket that is properly earthed through the standard electrical wiring.