Operation Manual

88
Fuser Error The temperature of the fuser
unit does not rise to a specified
temperature within the
specified time.
Press and hold down to turn the machine
off, wait a few seconds, and then turn it on
again. Leave the machine idle for 15 minutes
with the power on.
The fuser unit is too hot.
Jam 2-sided The paper is jammed
underneath the paper tray or
the fuser unit.
See Paper is jammed underneath the paper
tray on page 101.
Jam Inside The paper is jammed inside
the machine.
See Paper is jammed inside the machine
on page 98.
Jam Manual Feed The paper is jammed in the
manual feed slot of the
machine.
See Paper is jammed in the manual feed slot
on page 94.
Jam Rear The paper is jammed in the
back of the machine.
See Paper is jammed at the back of the
machine on page 96.
Jam Tray The paper is jammed in the
paper tray of the machine.
See Paper is jammed in the paper tray
on page 94.
Limit Exceeded The number of pages you are
allowed to print has been
exceeded. The print job will be
cancelled.
Contact your administrator to check your
Secure Function Lock Settings.
Log Access Error The machine could not access
the print log file in the server.
Contact your administrator to check the Store
Print Log to Network settings.
For more information, see Network User’s
Guide: Store Print Log to Network
Manual Feed Manual was selected as the
paper source when there was
no paper in the manual feed
slot.
Place paper in the manual feed slot (see
Loading paper in the manual feed slot
on page 22).
No Belt Unit The belt unit is not installed
correctly.
Reinstall the belt unit (see Replacing the belt
unit on page 60).
No Permission Printing colour documents is
restricted by Secure Function
Lock 2.0. The print job will be
cancelled.
Contact your administrator to check your
Secure Function Lock Settings.
No Paper The machine is out of paper in
the paper tray, or paper is not
correctly loaded in the paper
tray.
Do one of the following:
 Refill paper in the paper tray. Make sure the
paper guides are set to the correct size.
 Remove the paper and load it again. Make
sure the paper guides are set to the correct
size.
Error Message Cause Action