User`s guide

38
Cannot De tect You installed a new ink cartridge
too quickly and the machine did
not detect it.
Take out the new ink cartridge and
re-install it slowly.
If you are using non Brother
Original ink the machine may not
detect the ink cartridge.
Replace the cartridge with a Brother
Original ink cartridge. If the error message
remains, contact your Brother dealer.
An ink cartridge is not installed
correctly.
Take out the ink cartridge and re-install it
slowly until it clicks. (See Replacing the ink
cartridges on page 31.)
Cannot Pr int
Replace I nk
One or more of the ink cartridges
have reached the end of their life.
The machine will stop all print
operations.
Replace the ink cartridges. (See Replacing
the ink cartridges on page 31.)
Cover is Open The scanner cover is not
completely closed.
Lift the scanner cover and then close it
again.
The ink cartridge cover is not
completely closed.
Firmly close the ink cartridge cover until it
clicks.
Data Rema ining Print data is left in the machine's
memory.
Press Stop/Exit. The machine will cancel
the job and clear it from the memory. Try to
print again.
High Temp erature The print head is too warm. Allow the machine to cool down.
Ink Absor ber Full
Internal servicing required.
This problem may be caused by
the use of cartridges other than
genuine Brother Original
cartridges or the refilling of empty
cartridges with ink from other
sources. If damage is caused to
the print head or other parts of this
machine as a result of using other
brands of ink or ink cartridges, any
repairs required as a result may
not be covered by the warranty.
Call Brother Customer Service / your
Brother dealer.
Ink Absorber NearFull The ink absorber box or flushing
box is near full.
Call Brother Customer Service / your
Brother dealer.
Ink low One or more of the ink cartridges
are near the end of their life.
Order a new ink cartridge.
Low Tempe rature The print head is too cold. Allow the machine to warm up.
Media Err or The memory card is either
corrupted, incorrectly formatted,
or there is a problem with the
memory card.
Put the card firmly into the slot again to
make sure it is in the correct position. If the
error remains, check the media drive (slot)
of the machine by putting in another
memory card that you know is working.
Media is Full. The memory card you are using
already contains 999 files.
Your machine can only save to your
memory card if it contains less than 999
files. Try deleting unused files to free some
space and try again.
Error Message Cause Action