Mass Deployment Tool User's Guide
Table Of Contents
17
(m)apply
“mapply” 命令必
须使用 “profile”。
“Device identifier” 或 “profile”
是必需的。
1
● Device identifier
必需:
● file
可选:
● password
● skipvalidate
● profile
必需:
● result
可选:
● profilepassword
● csvdelim
● createfileonly
● outputdir (*)
必要时同时提供:
● schema
● pjltable
● enumtable
● forcepjl
● forcenative
● ignorepjlerror
● skipverify
● networksettingpath
● dkeypassword
● dkeyfile
●log
● communitynameset
● communitynameget
● forcehttps
* 如果使用 “--createfileonly”,
必须也使用 “--outputdir”。
可让您发送和应用指定的设置文件并确认结果。支持 JSON、
DPK 和 EDPK 文件。
如果将 “mapply” 命令与 “--outputdir” 选项结合使用,工具会
将每个设备的中间文件输出到指定的文件夹中。
如果将 “mapply” 命令与 “--createfileonly” 和 “--outputdir” 选
项结合使用,工具只会将每个设备的中间文件保存到指定的
文件夹,而不会将文件应用到每个设备。
示例:
settingcmd.exe apply --ip IP_address --file
your_file_name.json –-password your_password
settingcmd.exe mapply --profile
your_profile_name.csv --result
your_filename.csv
在结果文件 (CSV) 中确认每个设备的结果。结果文件包含部
署配置文件中的所有项目以及下列项目:
- Result
- Detail
- Start time
- Finish time
- (可选)输出:如果将 “(m)apply” 命令与 “--outputdir” 选项
结合使用,将会在此处显示保存中间文件的路径。
retrieve
必需:
● Device identifier
● output
可选:
● file
● password
● networksettingpath
●log
● communitynameset
● communitynameget
● forcehttps
可从指定的设备检索所需的特定设置数据。
该工具向指定的目标设备发送请求,并存储检索到的设置数
据,其中包括基于指定文件路径的 JSON 架构中的所有设置。
要只下载特定设置,请使用 “--file” 选项来指定包括所需项目
的设置文件。
示例:
settingcmd.exe retrieve --ip IP_address
--file your_file_name.json
--output your_file_name.edpk
--password your_password
命令 选项 说明